F1 Corner Analysis: Speed and Braking
About this chart
What it shows. A close-up comparison of two drivers' fastest laps over a stretch of track you choose with the distance slider, typically one corner or a sequence of corners.
How to read it. There are four panels sharing one horizontal axis, distance along the lap in metres. The top panel is speed in km/h, with a note of which driver was faster on average and by how many km/h over the chosen stretch. The second and third panels are longitudinal and lateral acceleration in g: braking shows as a dip below zero in the second, cornering load in the third. The bottom panel splits the stretch into full throttle (green), lift (grey) and braking (red) for each driver. Lines use each team's colour, so team-mates share one.
What to look for. Compare where each driver's speed starts to fall: the later braker usually has the red band starting further along the bottom panel. Then look at the lowest speed through the apex and how early the green band returns. A driver who brakes later but has a lower minimum speed may lose on exit what they gained on entry.
Data and caveats. Car telemetry for each driver's fastest lap from the official F1 timing feed, processed with FastF1 and published by TracingInsights. Acceleration values are calculated from speed and position rather than measured. The slider runs from 0 to 7,100 m on every circuit, so set it within the actual lap length; the vertical scales cover the whole lap.